problem interference detected

[braunfish]

why inventor detects a interference for example between a screw and its threaded hole?
It is a big problem because when I go to animate constraints with the option of detecting interference between bodies, animation stops immediately because of those vines that are actually useless at the end of animation.
I hope I've explained

 

[Ilario]

maybe because in the holes display options you set smaller hole or pre-cut hole, you should set (for this case) larger hole

 

[davide75]

but doing so when I put the threaded hole in the table is not properly represented, is it? ?

 

[Daniele_69]

detects interference because the hole is calculated on the inner diameter, while the screw on the outer diameter. the solution is that proposed by the Ilario, but it is then true that the threaded hole is not displayed correctly (just test it and then adjust the document settings).
other solution could be to use the level of detail that is called "all the suppressed content center" so it suppresses all the screws (attention: it also suppresses all other standard components). currency you from time to time as it is best to proceed.
Hi.

 

[Ilario]

Yes, of course, but in fact we talk about the animation with collision detection and I specified in brackets "for this case"... normally according to me it is better the prefixing hole, but obviously makes interference

 

[pagnotz]

other solution could be to use the level of detail that is called "all the suppressed content center" so it suppresses all the screws

I would do so

 

[davide75]

it would take as if the option not to calculate the interferences due to the thread

 

[braunfish]

I would do so

Thank you very much.
I didn't think about it.