disegno2d

hello to all, I am going to a student of mechanical ing at the athene of bologna. I've been following the forum for a while and finally I've decided to enroll myself taking advantage of the fact that I wanted to ask for your opinions about a mechanical design/design exercise. I would point out...

Good morning, everyone. question to which I personally cannot answer. in drawing 2d it is correct to use drawing scales that are not 1:1/1:2/1:5/1:10/1:20 etc. etc. type for example 1:1.5/1:3 or others. Thank you in advance.

Good morning. someone who can help me to make a serial quotation on nx 12. thanks in advance

Good morning. I need your kind help. often I happen to have to display in a table a section of a set that is composed of a series of single components very small one next to the other as you can see in the figure . being that I must then print it in a4 format is a completely black block even...

hi, everyone is new in the forum, I am a student of architecture struggling with the thesis and in this period I am using the sw program that I find fantastic, but still has some secret for me; In fact I would like to know if and how it is possible to open a 2d drawing file (slddrw) with a...