drawing

Hello I have a doubt on the following table: Are the odds of the bevels on the bigger shoulder? I tried not to insert a serial quota to size them but I'm not sure of the result Thank you very much =

Hi. on drawing I exported a dwg of a cartiglio and emptied me every letter Is there a way to fill them? Thank you.

Hello. are pierluigi, I would need information about the norms on the ball (or bubble). In particular, I would like to know if it was correct to indicate the number of the component to all the components present in the axieme, even if they are used several times (for example: screws, washers or...

Hello everyone, I am new in the forum, I did a brief research on my problem but I did not find anything special, so I hope someone can help me. realize that you have drawn a tube that makes a certain path and that occasionally there are anchor points identified with a part (the usual) but with...

Good evening to all, I wanted to ask if it is possible to preconfigure a drawing template, so that the quotas assigned to the model are automatically provided with tolerance, with value equal to the deviation prescribed for the quotas that would be without tolerance. I'll explain. if in the...

Hello everyone, I'm new to the forum but it's been a long time since I've been following you, many answers from other posts have been very helpful and I hope to find a solution to this doubt too:wink: I am using catia v5 to make drawings connected to each other by public elements: in practice...

Good morning. I have component with various configurations, in the table setting (the .slddrw file) I put various sheets with a configuration in each sheet. now I have to export every single sheet in different pdf files and each file must be called with the drawing code (which changes from...