Good morning to all, I am new on this site.
I wanted to ask for help, I'm looking for a book to design mechanical gears.
the title of the book is as follows: theoretical and practical treatment of gear volume 1 and volume 2 written by georges henriot.
seems introvabile both pdf and paper
Could...
Good afternoon to all,
I'm a 22-year-old electronics graduate. I started following this community about a year ago, when I started this project and I have to say that it was very helpful. as I told you the mechanics is not my bread, so I hope you can forgive my mistakes. I studied it...
Good evening to all,
I would have a doubt that I couldn't find answers.
with a 2.5 module, we have:
- a moving wheel m
- toothed wheel b (z=24)
- toothed wheel (z=29)
imagining to connect the 1st block with the 2nd as in figure, I have special conditions for the toothed wheel c?
i.e., in...
Hello everyone, it is the first time I write on this forum, I am a student of a technical institute, I write this 3d since in the study of the dense wheels I have arisen a doubt: for the sizing we have been told to use the formulas of lewis (for the bending) and those for the surface pressure...
Hello everyone,
I find myself calculating the deflection of a tree on which a toothed wheel is mounted: I have to verify that it respects the condition of about 100 microns max for the more restrictive general engraving and condition (l/3000 for centrifugal effects says) equal to about 50...
