progettazione meccanica

Good morning, I just approached the world of mechanics, and I was beginning to design bolt nuts and a steel cassone. I wanted to ask if there was a table with the measurements to draw the inserts and bolts. I want to design everything alone as much as possible. Thank you very much.

hello to all, I am a student of mechanical ing and attended polytechnic, I would like a comparison regarding the correct representation in 2d of the components with the regulations of the technical representation of this mechanical assembly. the design represents a reducer of a straw

Hi, I'm a mechanical engineering student and I'm at the last exam where I'm having some trouble. the professor assigned us a project regarding the design of a lifting winch. starting from the initial data, such as: maximum load to be lifted 38kn, height to the hook 7 m , lifting speed 10 m/min...

Good morning to all, Being a reader of this forum for a long time since I consider it one of the few good Italians in the technical field, I decided to register to actively participate in the community trying to make my contribution in the future. I open this discussion because now more than...

Hello, I am 21 years old and I am passionate about mechanical design, I have a diploma from aeronautical expert and a design certificate with catia-v5 software. If you want to pursue a career as a designer, what do you recommend me to start doing? ps. I am that the request is poor info and a...

Hello, I am a new user, I would need your help to know if my bearing design of my gearbox is done well. I had designed the bearings so that the one above is a hinge and the one below a cart, but I'm not sure that I mounted them in the right way. Could you give me some advice or maybe some files...

Hello everyone, I know it might be a little strange question, but I'm literally freaking out to find the following books: -g. niemann, h. winter, ''elements of machines'', vol. 1, ''design and calculation of couplings, supports, trees', ed. science and technique, milano, 1983 - g. niemann, h...

Hello everyone, I'm new and so I introduce myself: zitux, I am a mechanical designer with a strong passion for 3d printers, quickly ascending. I write both in this section and in the most specific one dedicated to us designers to see if someone helps me solve my dilemma. I like to cuff on 3d...