riduttore

I'm a high school boy who has given me the complete design of a gearbox (from material choice, bearings, wheels, etc.) . My problem arises a bit in doing the initial draft, in fact today I have proposed a sketch to my professor but he has “buddled” me saying that I can do better in order to...

hello to all, I am a student of mechanical ing and attended polytechnic, I would like a comparison regarding the correct representation in 2d of the components with the regulations of the technical representation of this mechanical assembly. the design represents a reducer of a straw

hello to all, I am going to a student of mechanical ing at the athene of bologna. I've been following the forum for a while and finally I've decided to enroll myself taking advantage of the fact that I wanted to ask for your opinions about a mechanical design/design exercise. I would point out...

I have no idea how to start this project. ..you're gonna smoke me.

Hello everyone, my name is christian and I am a student of industrial engineering and I am preparing the technical drawing exam, I wanted to ask, being new of the forum, if you could give me a hand to understand if I can correctly interpret assiemi and extract the specific component, since the...

Good afternoon to all, I'm a 22-year-old electronics graduate. I started following this community about a year ago, when I started this project and I have to say that it was very helpful. as I told you the mechanics is not my bread, so I hope you can forgive my mistakes. I studied it...

hello to all, I should realize the project of a two-stage parallel axle reducer following these indications: 1) the driving machine is an internal combustion engine, of 90kw power, which at a wheel rate of 2250 rpm 2) the machine operated, on a regimen, rotates to 375 rpm and is not subject to...

Good morning. I am making a sizing to turn a platform by 90°. weight 300 kg, baricentro about 250mm from the rotation axis. I had thought of using a 340mm diameter manoeuvre handwheel connected to an endless screw reducer. hypothesized a 1:30 report, I have that on the flyer, less than the yield...

a 1-stage epicycloidal reducer with i=5 reduction ratio, with a nominal input speed of 4000 rpm and a maximum output torque of 180 nm. Whereas a maximum diametrical encumbrance of 100 mm, define the parameters relative to solar, satellites and hatch. draw in 3d the reducer, representing only in...

Hello! ! I am designing a cycloidal reducer and to reduce the vibrational problem I have to balance the centrifugal force of the eccentric. on the web I have seen that the most common solution is to use a two-stage cycloidal reducer so that the second cycloidal disc complies with this...

Bye to all, I have to design an irreversible epicloidal reducer without the use of a car. Can you help me by telling me how I can achieve the irreversibility of the system? What parameters should I consider? Thank you.

hello to all, as from title I have a doubt (lieve to tell the truth) on the verses of the forces agents on a reducer. I attach an image of the unifilare pattern of the reducer and a hand sketch of the agents forces. I thank everyone who decides to help me, I realize it's nonsense but it's better...

It is the first time I open a discussion in this forum, so I hope I do not miss the section and do not break various rules of the regulation, in which case I apologize earlier. the question that I ask you is the following: in the middle shaft of a two-stage reduction gearbox with parallel axes...

Hi, I press that before opening this new discussion I have displayed a lot of posts about epicyclical rotisms also using the "search" function but I couldn't find the answer to my question. I have to carry out a project for the examination of mechanical design i specifically it is to design an...

Hello. I'm a mechanics student and I have to dimension a conical wheel reducer. for the pinion I did not find any difficulties but I do not know what with the shaft (but solved before). I tried a little alone but I stopped because the wheel is mounted in the middle and I know that it produces...