activate rappr. simplified a prt in drw

[lollone]

Hey, guys.
I need to make 2 tables of a prt.
in the first sheet I want to insert the finished detail, in the second sheet the prt without some features to show laser cutting processing.
To do this, I think I'm pretty sure to say I have to do a rappr. simplified by omitting the features I don't care about.
But when I want to change the active representation in the drw, I don't charge other representations outside that base.
Can you explain why?
Is there any command in the config to set?

Thank you. .

 

[lollone]

Excuse me...
I looked better and found it!
My crib!!!

 

[SweptBlend]

and why not a family table, in which from the drawing,
Are you going to place the views of the various istance?

 

[lollone]

Yes, it's the same thing!
I didn't understand why I couldn't see it!