aiuto per gbg dm v.6.0h

[damarino]

Good morning to all,
is there someone who knows how to create symbols within gbg dm v.6.0h?
As an example, I would like to create a new cartilage to be saved and porter recalled to need.

thanks for the vs. attention

 

[Techspell]

It's a bit dated software (it's over 20 years old).

Now thinkdesign is proposed that has both part 3d and part 2d.

 

[damarino]

Unfortunately we are still very close to gbg for the following reasons.

1) retrocompatibility with our park drawings in .d format: we have 2009.3 hypercad-s 2013 of openmind, but exporting a design in .d is not read by gbg v.6.0h.
this binds us to continue using the old gbg.

2) being a small company, much of the work in the technical office is still in the hands of the owner, who knows gbg very well. It is therefore difficult to assume and propose a replacement of the software.

 

[Techspell]

really thinkdesign can save both in 8 and higher format (default value) and in 5,6,7 format (activable by selection of options).

so even if the owner was pleased to continue using gbg 6.0, other users could use thinkdesign quietly