analisi floxpress profilo alare "sw 2011"

[Richart]

hello to all boys, compliments for the excellent forum you created and how you keep it egregious.

As mentioned by my presentation in its space I am a student of the v year of an industrial technical institute to address aircraft constructions.

My intention would be to recreate a wind tunnel and make measurements through a wing floxpress. Unfortunately even if I followed the native sw tutorial I can not create in the tunnel, or the "covers" of it.
another problem that I couldn't overcome and create a wing that has the positive arrow, I can only create rectangle wings through the simple extrusion of the created profile.

I hope in your help in both problems, hoping not to disturb you.

Thank you in advance!

 

[re_solidworks]

First of all welcome to the solidworks forum! It doesn't bother us at all, but I can't answer you as I can't use cfd analysis. We wait if there's someone who uses it and who can give you some tips.

 

[SolidUser]

First of all welcome to the solidworks forum! It doesn't bother us at all, but I can't answer you as I can't use cfd analysis. We wait if there's someone who uses it and who can give you some tips.

I move the question in the section fit.
if it talks about the cad solidworks.

 

[Richart]

I move the question in the section fit.
if it talks about the cad solidworks.

Okay! I didn't notice. "pardon"

 

[Swarzy]

Hello Richart,

I can tell you that with the floxpress module, although limited, you can perform the analysis you request.

for profile construction I recommend this document:
http://www.dur.ac.uk/g.l.ingram/download/solidworksaerofoilguide.pdfwhile, for the modeling of geometries, I attach the model I created so that you can take it as a reference.


available for further information.

Hi, swarzy.

 

[Richart]

Hello Richart,

I can tell you that with the floxpress module, although limited, you can perform the analysis you request.

for profile construction I recommend this document:
http://www.dur.ac.uk/g.l.ingram/download/solidworksaerofoilguide.pdfwhile, for the modeling of geometries, I attach the model I created so that you can take it as a reference.


available for further information.

Hi, swarzy.

Thank you so much swarzy, I can finally see floxpress in action!

Now I'll test myself and let you know! Thank you again! :biggrin: