anchoring point general table

[Solid User]

Good evening, everyone.

I created and saved two different general tables. Now I can't create two distinct anchor points.

I would like the general table to have its anchoring point at, while the general table b had another anchoring point b.

I'm always saved by default the last anchoring point you choose.


can you tell me if you can set a dedicated anchor point for each created general table?

Thank you, hello!

 

[MassiVonWeizen]

there are four possible anchor points, one by corner

 

[MassiVonWeizen]

always valid the rule to read the guide http://help.solidworks.com/2015/italian/solidworks/sldworks/t_table_anchors.htm
how you can read the anchoring point does not apply to the table, which are always on the corners, but to the square

 

[Solid User]

Thanks for the answer, I had already read the guide but that chapter does not concern the question I asked.

I would like to understand if there is a possibility of having different anchor points per various table generali.

cation

 

[MassiVonWeizen]

no because the selection of the anchor point to be defined can only choose the type of table and not the variant for single type