MaiMollare
Guest
Good morning
I can't place geometric tolerance using the leading dimension in the desired position. practically decides him if to place it on the right or left. is there somewhere a "flip" to move it to the right or left? .when the drawing is full of quotas I would like to have them all in the same direction and not as you see them in the figure.
thanks early
I can't place geometric tolerance using the leading dimension in the desired position. practically decides him if to place it on the right or left. is there somewhere a "flip" to move it to the right or left? .when the drawing is full of quotas I would like to have them all in the same direction and not as you see them in the figure.
thanks early
