ansys calculation displacement of a determined point and use probe function

[PLUTO8588]

Good morning.

Could someone tell me how to use the probe function on ansys?
Do I have to calculate the shift of a certain point of my chart? ?

I can't move on
Thank you.

 

[gerod]

next time you write in this forum I urge you to present yourself and read the rules of the same.
it is not possible to write 4 times the same request and in capital print.
The ammonition is of obligation and I ask everyone not to respond before you have ensured that you have complied with these mandatory fundamental rules and good behavior.
I forgot: call the assistance!
Thank you.

 

[PLUTO8588]

Excuse me, are you right what I have to do to get an answer from you?? ?

 

[gerod]

But did you read what I wrote to you?
I don't think I wrote in Aramaic!