panormus
Guest
hello and good 2012 to all.
I know that repeating a post is not the top of correctness, but I do it because I imagine that sometimes you always look at the same type of sections of the forum, do not harm the moderators.
I am learning how to use catia v5 thanks to the prof manual of the noble.
I'm drawing an aircraft and wondering how to pass a 3d design to a cnc.
I should pass:
1- list the pieces,
2- divide them by type of material,
3- lay them on a floor (included possibly the surface that being of canvas 4- I could cut with precision), so in case of particular form such as a cone or similar things, develop it on a floor,
5- divide them into sheets (so 2d) and each sheet contain pieces of the same material,
6- Pass them in dxf
7- give them to a friend with a 400 kg cnc that cuts the world,
8- take care of the reassembly.
Some aircraft designer (or not) knows how I could do and if these production steps have a name?
greetings
I know that repeating a post is not the top of correctness, but I do it because I imagine that sometimes you always look at the same type of sections of the forum, do not harm the moderators.
I am learning how to use catia v5 thanks to the prof manual of the noble.
I'm drawing an aircraft and wondering how to pass a 3d design to a cnc.
I should pass:
1- list the pieces,
2- divide them by type of material,
3- lay them on a floor (included possibly the surface that being of canvas 4- I could cut with precision), so in case of particular form such as a cone or similar things, develop it on a floor,
5- divide them into sheets (so 2d) and each sheet contain pieces of the same material,
6- Pass them in dxf
7- give them to a friend with a 400 kg cnc that cuts the world,
8- take care of the reassembly.
Some aircraft designer (or not) knows how I could do and if these production steps have a name?
greetings