automatic chart size

[MARCOC]

Good morning and for a while I haven't used inventor, and I have come a doubt, I installed inv 2015, when I do a sketch on a plane or on a face, in automatic inventor did not dissect the graphics, I remember badly, now I do a sketch and then I have to give it "graphic cut"...I remember badly I have and always been like this? ? ?

Thank you very much

 

[GreenChuck]

Hello, Marcoc.

that I remember not. the graphic size you should do it manually. instead there is the option of aligning the view to the sketch plan that you go to create and also that of projecting automatically the edges in the creation of the sketch. I hope I've been helpful.

hello and good day!

 

[AlessioTB]

Sorry if I insert myself but I just use invenor2015 and I can no longer cut the chart with f7. was the same command left or changed it?

 

[Zac69]

If you didn't change it, it's always f7