beam supported by circular section with ansys

[Giada89]

Hi.
I am using ansys workbench to do a static structural fem analysis (static structural) of a beam (imported by solidworks)

the beam we say that it is a cylinder and at one point I would like to put a support, in the other a cart.

what gives me difficulties is the setting of loads: I would like to put ''displacement' on those points but apply it on the beam axis, only that I can't create points on the axis because there is no

How can I put those loads? or does anyone have another idea about the model?
I also have to put a vertical force applied in halfway

solutions?

I think it's nonsense, just put the axis in geometry and the points where I want to put the bond... or is it too simple?

thanks in advance
Hi.

 

[gerod]

If you use a solid, the axis does not exist! !
How can you think of binding the axis of a full cylinder? if anything the cylinder will be bound on the outer surface.
Are you using ansys mechanical or ansys design space?
If you have to put a force in the middle of the car, you have to draw the model with a surface in the middle of the vehicle on which to force us.