bend retreats and factor k

[themole]

good morning boys, I press that I have always developed to calculator and pen.now I want to try with solidworks.it's possible to have a table of retreats (factor k) from 8/10 to 80/10 iron and know how to use it with the program?
I did some tests using the k factor on folds at 90 degrees and thinking with my experience in workshop.on folds at 90 degrees the program develops right on (example done with a 40/10) if I bend a flap at 15 degrees instead I get results incorrect. is there any good soul that illuminates me?
It's a topic I guess they've unseen all those who definitely use the sheet module.
signed.... an apprentice (not sorcerer).

 

[SolidUser]

the k factor put it by hand on each fold or keep it general or via excel data table.
the excel table, as you well know is a spreadsheet.
if you have a formula, use it to fill out this excel sheet which he will use dynamically, i.e. set a k factor by interpolating the data in the table.
read to courteous also the help.

 

[Mike1967]

good morning boys, I press that I have always developed to calculator and pen.now I want to try with solidworks.it's possible to have a table of retreats (factor k) from 8/10 to 80/10 iron and know how to use it with the program?
I did some tests using the k factor on folds at 90 degrees and thinking with my experience in workshop.on folds at 90 degrees the program develops right on (example done with a 40/10) if I bend a flap at 15 degrees instead I get results incorrect. is there any good soul that illuminates me?
It's a topic I guess they've unseen all those who definitely use the sheet module.
signed.... an apprentice (not sorcerer).

Give me a shot here:http://www.cad3d.it/forum1/showthread.php?t=20305as already discussed, you must find the k factor values based on the used molds, not
It is said that my values apply to your fold equipment.
Hi.

 

[themole]

step-by-step you would then tell me how and which excel file set according to the k factor - of the fold angle - of the thickness?