cam bond

[fabri1979]

Good morning to all I'm drunk, I've just introduced myself. I have a small problem in a set consisting of a cam that pushes a rootina placed on a fork that can flow along a axis with the constraint. when I act on drag components the cam rightly moves the ruotine and the fork, but the ruotine remains motionless without turning on itself (although it has a pin bond), maintaining only the tangence to the cam. I wondered if there was a way to turn the ruotine when the cam turns. (I tried to look in the various discussions but there was nothing on this). thanks to all

 

[fabri1979]

at the moment I partially solved by putting 2 engines, one on the wheel and one on the cam. But I would like to understand if there is another way.

 

[DANI-3D]

Hi.
a method could be go into the mechanism module and choose gear, rack pinion.

 

[fabri1979]

Hello, thank you for the answer!
I tried but I couldn't do it because I'm going to lose the cam bond. I put a picture of the mechanism, because maybe I explained not too well. If you have time to take a look. Thanks again

 

[DANI-3D]

I did some evidence, because I didn't remember well. You have to do this:
do not use the rack pinion system, but couple of gears, then go to the properties and tick off the creation of an internal carrier body, I did not understand what it means, but it works.
you will not get a simulation perfectly true to reality, because doing the rotation speed of the two components is the same, just as if there were two gears, but it is better than nothing ... then if they come out other methods are well accepted.

 

[fabri1979]

Thank you so much! following your advice I managed and it works! great:finger:

 

[DANI-3D]

Thank you so much! following your advice I managed and it works! great:finger:

Please.
How do you feel about movement?

 

[fabri1979]

Please.
How do you feel about movement?

The movement is fine, it's realistic! I'd say almost perfect. I couldn't have done it on my own.