AMKDS67
Guest
Good morning.
I just started using repetier hosts, and I generated several printing routes with a r2 itch.
I happen that with a model (geometrically without problems) in the calculation phase with curaengine does all the procedure normally but ultimately does not generate gcode (empty condition).
What could be the problem?
I just started using repetier hosts, and I generated several printing routes with a r2 itch.
I happen that with a model (geometrically without problems) in the calculation phase with curaengine does all the procedure normally but ultimately does not generate gcode (empty condition).
What could be the problem?