centering pockets

[Esselle]

good morning, when I remove from a particular set with holes or sunshades, I find then in the relative table of the "fantasm" centering notches like those in the image. I have always removed all "fantasm" heels by hand one by one, but is there no different method?

edit: same thing happens to odds associated with deleted details.

 

[teseo]

this behaviour is normal; At least for solids, you can do nothing but take them off.... .
Hi.

 

[MassiVonWeizen]

should settle down going in the options of the drawing document, in the details tab and popping up to the voice hide odds and annotations released.

if it does not work, to be evaluated according to the design, sometimes it can be less expensive or tiring to put all the notches back instead of eliminating one at a time those released. then you can set the filter centering notches, do ctrl+a and delete all the centering notches, done this you turn off the filter you launch the annotation and select the views in which to insert them.

 

[Esselle]

should settle down going in the options of the drawing document, in the details tab and popping up to the voice hide odds and annotations released.so it worked, within a design even quite complex.if it does not work, to be evaluated according to the design, sometimes it can be less expensive or tiring to put all the notches back instead of eliminating one at a time those released. then you can set the filter centering notches, do ctrl+a and delete all the centering notches, done this you turn off the filter you launch the annotation and select the views in which to insert them.
the filter centering notches instead I could not identify it

 

[MassiVonWeizen]

the filter centering notches instead I could not identify it

 

[Esselle]

Thanks, I didn't have the bar activated, now it's all clear!