change basic component of a derivative

[citri]

Hello everyone

Perhaps the title is not very clear, but you know if there is the possibility, having an ipt obtained from a derivative, then go to change the component "father"?

Thank you.

 

[TECNOMODEL]

Yeah, sure.
of course it also changes the derivative.
attention if it comes several times a particular in different parts.

 

[citri]

thank you technomodel for your answer but rereading how much I wrote, I realized that unfortunately I was not very clear, now I try again but it will be very hard to make me understand :wink:

I practically have a sheet-a1 and a sheet-a2, where the latter is created by a1.

later for convenience, and because I already made the table, I take sheet-a1 and the sheet-b1 rhino and I take sheet-a2 (derived part) and the sheet-b2 rhino obviously the problem what is now, that when I open sheet-b2, the base component remained sheet-a1 and here instead, I would like to go to change it with sheet-b1

 

[TECNOMODEL]

I think it's not possible.
However, you can "duplicate" the a2 sheet table and change the reference model by replacing it with the b2 sheet

 

[Cast16]

thank you technomodel for your answer but rereading how much I wrote, I realized that unfortunately I was not very clear, now I try again but it will be very hard to make me understand :wink:

I practically have a sheet-a1 and a sheet-a2, where the latter is created by a1.

later for convenience, and because I already made the table, I take sheet-a1 and the sheet-b1 rhino and I take sheet-a2 (derived part) and the sheet-b2 rhino obviously the problem what is now, that when I open sheet-b2, the base component remained sheet-a1 and here instead, I would like to go to change it with sheet-b1

in this case you will have the red question mark:solve the file-point on the new file

 

[stefanobruno]

I practically have a sheet-a1 and a sheet-a2, where the latter is created by a1.

later for convenience, and because I already made the table, I take sheet-a1 and the sheet-b1 rhino and I take sheet-a2 (derived part) and the sheet-b2 rhino obviously the problem what is now, that when I open sheet-b2, the base component remained sheet-a1 and here instead, I would like to go to change it with sheet-b1

rename sheet-a1 in sheet-a1--, open sheet-b2 and to the request of files not found, sheet-b1 points.

 

[citri]

Thank you so much guys, it works great! :finger: