antonio_sc
Guest
Good evening,
I created a filling pattern/series to be able to tilt a certain angle of the elements on a plate
However, by calling the axes from the model the situation is as follows:
Perhaps it will be banal, but I have found nothing about it: I can't understand how to orientate the axes of the centers of the various circular elements along the direction indicated in green in the image (actually rotate them by 30 °) once they are recalled by command "visualization of the annotations of the model"... in the office they told me to do sketch 2d to represent them but personally I find them uncomfortable to use and I would prefer to walk other roads (if it were feasible) ...
p.s. the green line is not present in the real table (it is just an indication to clarify the object of the discussion at best). .
I hope I have been clear and thank you in advance for the answers
I created a filling pattern/series to be able to tilt a certain angle of the elements on a plate
However, by calling the axes from the model the situation is as follows:Perhaps it will be banal, but I have found nothing about it: I can't understand how to orientate the axes of the centers of the various circular elements along the direction indicated in green in the image (actually rotate them by 30 °) once they are recalled by command "visualization of the annotations of the model"... in the office they told me to do sketch 2d to represent them but personally I find them uncomfortable to use and I would prefer to walk other roads (if it were feasible) ...p.s. the green line is not present in the real table (it is just an indication to clarify the object of the discussion at best). .
I hope I have been clear and thank you in advance for the answers
, they could give him a name a little more "happy":roflmao:. .