change the thickness of the lines

[Sundip96]

Hello guys I need a clarification:
After I make a split view, I put it on the table and the mold prints me the section spline with big line how do I set it as a fine line?

 

[Filo]

click with the right over the line->properties then a drop-down with written line thickness and choose the one that best suits you.

the thing that I can't do either is automatically set the thickness of the spline, inventor puts it with the same thickness used for the edges and is not correct.

Hi.

p.s. a better title would have been "change the thickness of the lines in a split view" :biggrin: