change value

[picc]

Hello everyone!
for a project at university I had to use a mothervite with tr60x9 thread. I managed to insert this particular measure into the toolbox "creation wizard" (as indicated in another discussion on this forum). the problem I have now is that in the design of the part when I go to quota appears the word "m60x9"! how can I change this value while maintaining tolerances?
Thank you all for your availability!

 

[MassiVonWeizen]

Meanwhile in the part change the cosmetic thread by putting the correct wording.
pou in the drawing if you use the caption holes should appear compiled correctly; if you use the normal share in the property manager you can edit the quota.
later I make a try and I know to be more precise

 

[MassiVonWeizen]

well that you have learned to manage the toolbox, but it is best to do it for holes that are often used.
for a single hole just do the minimum hole and add annotation cosmetic thread

 

[picc]

Thank you so much for the answer! but my problem is that in the drawing of the part the quota that appears to me is m60x9, while I would like it to be displayed tr60x9!

 

[MassiVonWeizen]

in fact I have answered

in the drawing if you use the caption holes should appear compiled correctly; if you use the normal share in the property manager you can edit the quota.

 

[picc]

in fact I have answered

Sorry I didn't see the first message! Thank you very much for the courtesy!