[classic coupled plates cerig???? ? ? ? ? ? ♪

[volaff]

hello to everyone, I have a doubt that I can't solve.

I modeled two plates (shell) to the average surface therefore they will be to nodes not coincident, one of them is loaded while the other is not.


I have the need to go to couple the two plates, i.e. I would like the two plates to behave as a whole.

If I pull a plate, the other one follows that shot.

I don't remember that I could use command to mate the dofs of the two plates. . .

cerig, cpint?? ? ?

thanks to everyone for the attention.

 

[eih64]

How many times have you asked this question? Hard someone answer you given the previous ones.

 

[volaff]

actually. . .

Good Sunday! !