closing operator error

[NomeU]

Hello I have a problem, I have to turn a solid created for surfaces into a solid "body". after having made the union and then the composition give the command to close the surface with a volume but falls from the following error " closing operator: it is not possible to close an opening from the body selected by a single flat face". suggestions? thanks for the help

 

[ferrezio]

your surfaces are still open.
the peculiarity of the open area, is that its edges are not common so the commando fails to close the volume.

You have to track the open area, and close it.

Hi.

 

[NomeU]

Thanks for the answer. the problem is that by doing the connection analysis I discovered that there are many "microapertures", there is a way to close them all automatically or I have to do it "by hand"

 

[alpole]

you can, by means of the compose command set higher tolerance values to try to close
the openings... .
but I discourage you;
analyses the parts not closed, and perhaps
you will find the error,where surely
to the non-connection of profiles used to generate surfaces.. .
the best thing and anyway to close them manually
to the