cloud management of reverse engineering points

[volaff]

Hello, everyone.
I remember that catia has a module for import and management of a cloud of reverse engineering points.
would you know how to confirm and say what this form is, please?

Thank you in advance.

 

[Lettore espatriato]

Hi.

In theory it's 2, I think.

I usually use the typized shape editor (you find it, if you have it active, under start/shape) that allows you to import or export the clouds of points and to do some basic operation like the offset.

Then there is, I think also the shape sculptor, which perhaps allows to work the slate in a similar way to a surface/solid. but unfortunately I never used it.

 

[alessandro Brunetti]

Hello, everyone.
I remember that catia has a module for import and management of a cloud of reverse engineering points.
would you know how to confirm and say what this form is, please?

Thank you in advance.

hi depends what you have to rebuild, the basic concept is that this module allows you, to create sections , from which to start for the construction of sck or wf 3d . the output usually is a solid , or surfaces created in generative shape design, then an exact geometry. I hope you've been helped

 

[hex]

hi depends what you have to rebuild, the basic concept is that this module allows you, to create sections , from which to start for the construction of sck or wf 3d . the output usually is a solid , or surfaces created in generative shape design, then an exact geometry. I hope you've been helped

you could attach the pdf or the file of the documentation.