command error "task"

[Francesco Maria]

hello to all boys, I've been using cats for a few days and I've been facing a problem that I haven't been able to respond to in my colleagues' experiences.
for this reason I address you:
to make it simple I'm trying to apply the pocket command on a solid to make the last modeling, the problem is that the command is working backwards (like the "prism" command to mean us). allego photos
Can anyone direct me?

 

[Lettore espatriato]

I'm not sure I understand your problem well, but the commands that assume a "emptying" of material (hole , pockets, etc ) if created in a separate body and by themselves, are displayed as "addition of material" . If then continue and add the body to the main body , it should be displayed correctly (at least so it works with the hole ) .

 

[Mastello]

I'm not sure I understand your problem well, but the commands that assume a "emptying" of material (hole , pockets, etc ) if created in a separate body and by themselves, are displayed as "addition of material" . If then continue and add the body to the main body , it should be displayed correctly (at least so it works with the hole ) .

hi the commands you perform them on the contrary because the solid on cu you are working is started with a feature of removal material type pocket / tab / hole / groove , in fact looking at the image you will see that in your body you have the sign - that is to indicate what I just mentioned, therefore if you want to remove material to a solid negative you have to use a feature that adds material type prisma / coast / tree, I hope that I can have you state of help.
Hi.