command/macro

[punto]

Bye to all,
do you think there is a macro or some command that allows me to create for each part its design(dft)? which then perhaps correct/adjust quotas or other for its realization? thanks 1000:smile:

 

[punto]

oopps, in solidedge st:finger:

 

[checco03]

that I know of standards there is nothing: you have to write a customization .net (however little stuff, maybe just a few dozen lines of code).

 

[gerod]

and still depends on how you insert the piece.
So many times, for a messed up piece, do you need to put it on the table with a view from a face... and there how do you do it?
should be intelligent this macro.
Hi.

 

[Be_on_edge]

If you tell me exactly how to behave, I'll do it.

Hi.

 

[punto]

Just put the part on the paper, and then I'll run. thanks:finger:

 

[Be_on_edge]

Just put the part on the paper, and then I'll run. thanks:finger:

random views?!

and then where's the advantage if you have to correct them by hand?

I remember a very useful function together especially.

dx key on the component and then "create drawing"

Hi.

 

[punto]

I didn't remember this:

thanks:finger:

 

[cacciatorino]

dx key on the component and then "create drawing"

Hi.

associating it to the quick sheet maybe takes another step forward.

 

[punto]

Thank you...