connect with work plans

[raffaele89]

Good evening.

I wanted to ask you, if you can collect more lines created by different work plans.
I tried but I can't.. .

thanks

 

[TECNOMODEL]

If they are different sketches no, if it is a 3d sketch I think you even if I use them really little.

 

[raffaele89]

If they are different sketches no, if it is a 3d sketch I think you even if I use them really little.

thanks for the answer

cmq these lines serve me to make a path of a pipe, and I needed the fitting to give the radius to the curves and then perform the sweep...
at this point if I cannot use the fitting once the sweep is performed how can I perform the radii of the curves?

 

[TECNOMODEL]

3d sketch

 

[raffaele89]

ok provo subito
grazie

 

[raffaele89]

but how do I set the length of the lines on 3d sketch?? ?

 

[raffaele89]

thanks to the same

 

[TECNOMODEL]

I don't use them, I did a flight test, just edit the length you want while you create the curve.
or the quoting as on the 2d sketch