psychonaut
Guest
Good morning, everyone!
I write because I would like to make a static simulation on a plate where there is a support for an oleodynamic cylinder, and I need to make a contact between the two pieces. I tried with the contact manager, but I still couldn't use it well; I would have a doubt:
I can well select the elements of the support, but not the elements of the plate, as the contact is three-dimensional, how can I do? I tried to insert in different connectors the contact elements, but it gives me several warnings in ansys: is it the right way, or is there any more immediate method?
Thank you very much for the answers, good day!
I write because I would like to make a static simulation on a plate where there is a support for an oleodynamic cylinder, and I need to make a contact between the two pieces. I tried with the contact manager, but I still couldn't use it well; I would have a doubt:
I can well select the elements of the support, but not the elements of the plate, as the contact is three-dimensional, how can I do? I tried to insert in different connectors the contact elements, but it gives me several warnings in ansys: is it the right way, or is there any more immediate method?
Thank you very much for the answers, good day!