marulanda
Guest
Hello everyone, I would like to ask you a question, I have a problem with an assy model.
I have six pairs of surfaces, four are in contact before and after lacio with loads. the other two pairs have a small gap (0.5 mm) before launch and come into contact later.
I used a sol 101 with bctable, no glue contact.
but the surfaces that are in contact before launch are processed correctly, instead the other two are not.
nastran does not recognize that the other and pairs of surfaces come into contact.
Does anyone have an idea why there is this problem?
Thank you very much.
greetings
I have six pairs of surfaces, four are in contact before and after lacio with loads. the other two pairs have a small gap (0.5 mm) before launch and come into contact later.
I used a sol 101 with bctable, no glue contact.
but the surfaces that are in contact before launch are processed correctly, instead the other two are not.
nastran does not recognize that the other and pairs of surfaces come into contact.
Does anyone have an idea why there is this problem?
Thank you very much.
greetings