s.rostagno
Guest
Good morning to all,
performing an interference control in navisworks for intersection with tolerance 1 cm I noticed how some elements, example structural pillar and architectural wall that are superimposed are not identified as interference. if imposed tolerance 0 or a control for conservative intersection are identified. someone can tell me how to proceed, my goal is to report all interferences greater than 1 cm including therefore amche the overlaps.
Thank you.
performing an interference control in navisworks for intersection with tolerance 1 cm I noticed how some elements, example structural pillar and architectural wall that are superimposed are not identified as interference. if imposed tolerance 0 or a control for conservative intersection are identified. someone can tell me how to proceed, my goal is to report all interferences greater than 1 cm including therefore amche the overlaps.
Thank you.