conversion from spline to arc into skech

[fabmorse77]

Hello, everyone.
Does anyone know if there is a command or a quick way to create 2 to convert a spline into an arc in the sketch environment?
this because when I go to create the table I need to quote these curvatures as rays but if they are spline you cannot quota.
Thank you for your help.

 

[StefanoAntonio]

I still use the wf4.
in anbiente sketch there is the change/replace command.

in practice when you are in sketch environment just draw a bow near the spline and then execute the change/replace command.

But I don't know if this is your case.

 

[fabmorse77]

Thanks stefano, however, I already know this (analogue method;-) ...it is not always the optimal solution because it is still necessary to redesign the bow and then replace the spline seldom obtaining the desired results and wasting a lot of time according to the complexity of the design. for this reason I wondered whether there was a function or a way or creating a macro etc. that could automatically perform this conversion. . .
other advice? Thank you.

 

[gio14]

I don't think it's possible (if you don't try to fit a bow) for a mathematical question

 

[fabmorse77]

...I'll see if I can make up something. Thanks again