copy/paste from autocad on sw2007?

[pigellik]

using sw2007 I had the following problem:in sketch mode I can't glue profiles copied by autocad on the chosen sketch plane ,but they remain glued as ole objects released from each floor,and therefore not exploitable for subsequent extrusions or anything!How ever? Thank you.

 

[re_solidworks]

using sw2007 I had the following problem:in sketch mode I can't glue profiles copied by autocad on the chosen sketch plane ,but they remain glued as ole objects released from each floor,and therefore not exploitable for subsequent extrusions or anything!How ever? Thank you.

Hello lazyellik,
I see it's your first post and first I invite you to introduce yourself to the special area. I also invite you to read the rules and you will find that it is forbidden to write all capital as it is equivalent to screaming.

coming to your problem I don't know, if I don't remember wrong 2007 supported the past copy from autocad (it's been a while since I used it last time).
I know that the correct procedure plans to copy objects, go into a sketch, select a reference point (I always took the origin) and paste. Do you do this?
otherwise you can try importing the dwg directly into one part (even empty) and then make the paste copy from the blank part to the part of your interest.

 

[pigellik]

Thank you, tomorrow at work I will try!as you see I am a neophyte both on cad3d and on sw!!
Say hi.