corrugated sheet for roof

[frock87]

hi to all, use revit 2010 and I would need a hand to correctly represent the structure of a cover as corrugated sheet.

I would point out that I have already understood how to represent the Greek plate, i.e. by realizing the profile pillars that I need to place them on a cover represented as a sloped glazing....I was therefore wondering whether the procedure could be similar or if there was a better way to represent them. ....

there are some similar posts on this type but I had difficulty finding a discussion dedicated only to this structure...I know that in the representation of the state of fact this type is very widespread, I hope that your help can serve me as to many others in my own situation.

Thank you in advance

 

[gfrank]

go to the section "video" and see how to build the roof with tiles 3 d. instead of the tiles, replace the tile with a "wave of sheet"

 

[frock87]

thanks I am following your advice

 

[sardegna2015]

Hi.
Sorry I just signed up.
I also try to model a roof on revit 2010 but did not find the video of your message!

 

[gfrank]

Actually, there is no more...
see in this discussion (post No 16), there should be ...:http://www.cad3d.it/forum1/threads/3381-coppi-in-3d?highlight=tegole