coupling of standard profiles

[braunfish]

in one set, in addition to single parts, I have two ipe100 profiles 2 meters long equal.
in the table, in the list table parts, writes me 1 piece ipe100 long 4 meters (accorpa). instead I would like you to write me 2 pieces ipe100 long 2 meters.

 

[Catafratto]

First of all, hello,
I tell you what I did at the time, changing the style of the list parts:
- as quantity I set qta elements (which counts the actual number of occurrences
- under grouping I set nothing
- as a cut I set a g_l parameter, flagged for export (which I saw used by 100 content), and I connected the measurement of my profiles to this and then the list parts to g_l.
- I made sure that in the template (not table) that I use the basic quantity is set on g_l

to note that the grouping takes place according to the number part (regardless of the file, as it could happen with the chassis generator), so if you have to say 5 pieces with different cut and the equal part number gets high all; Likewise, 5 equal parts with equal cut but no different part will be 5 distinct rows. I hope I've been clear, even if I don't think so;-)

p.s.
for example in my models I would have your ipe100 with n°parte ipe100x2000, n°magazzino ipe100. I don't know if it's the best method but my workflow works.