create a washbasin

[qui]

Hello, everyone.
I have to draw a washer (outside 350mm thickness 5 mm, which must then be curved on a tube whose diameter is 700 mm). I therefore have to create a developed one that allows me a proper laser cut, then to turn the laser cut, so that the washer goes to lie on the circumference from 700mm.

If I try to draw the sheet, it doesn't spread.. .
Attached find the jpeg of how it should come.

accept ideas...
steak

 

[Oldwarper]

depends on how you did it.
if intersecting two cable cylinders, you have no constant thickness.
If you did it with a constant thickness you need a straight edge. to do this you have to radially cut the washer along the washer generator at the maximum point of bending, maybe even a few cents.

edit: no, it doesn't work. with logopress I can insert a very small floor in the same direction indicated. but the sheet does not recognize it.

Maybe with the sheet with loft, but no idea how to make it work well in your case.

Sorry:frown:

 

[Mike1967]

You mean that?

 

[qui]

You mean that?

Exactly like that!
Great.
conceptually I had done the same thing, but development did not come.
I noticed that you made the sheet from a line, I chose a profile, equal to the thickness of the sheet. Probably the opposite is right there.

Thank you!

steak

 

[Mike1967]

Exactly like that!
Great.
conceptually I had done the same thing, but development did not come.
I noticed that you made the sheet from a line, I chose a profile, equal to the thickness of the sheet. Probably the opposite is right there.

Thank you!

steak

happy to have helped you!
Remember that in the sheets there are a lot of ways to design.
not always the most logical is the right one.


:finger: