create customized 2d table sizes in alibre

[gregario]

I would like to create custom sizes for table 2d, but I can't figure out how to create new ones trying to exploit the software's tamplates.

I've just bought it and I'm just cuffing it and for a little while, so I don't know much about the potential of progrgamma... .

Who can help me with a few tips? I would also like to insert a logo in the paper... .


hello and thank you in advance for the answers

 

[Preparation-H]

when you start alibre, create a new table, in the bottom "create empty design" and open a template of the already existing ones, you position on the square and button dx, explode symbol, by changing them and put what you want.. .
if you check in the help should be explained to great lines how to do.. .

for the logo you must insert it as jpg or as image... if not too complex you can import a dxf into a new sheet expodes and cups in the cartilage. . .

(I then recommend to select the cartiglio and save it as a symbol, when you change the other templates delete what you don't care and import the new cartiglio... )

Hi.
p-h

 

[gregario]

when you start alibre, create a new table, in the bottom "create empty design" and open a template of the already existing ones, you position on the square and button dx, explode symbol, by changing them and put what you want.. .
if you check in the help should be explained to great lines how to do.. .

for the logo you must insert it as jpg or as image... if not too complex you can import a dxf into a new sheet expodes and cups in the cartilage. . .

(I then recommend to select the cartiglio and save it as a symbol, when you change the other templates delete what you don't care and import the new cartiglio... )

Hi.
p-h

Thank you very much, I try now!!!! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !

Hey!