create note with the name of the part

[mali_fx]

I would like to create a note that automatically takes the name of the part!
How can I do that?

 

[apple]

proof &model_name

 

[mali_fx]

Thank you so much apple!

 

[mgdi]

...but if I do it in a set, I get the name of the axieme. .
I explain, in a table I should indicate with a note the name or code (by parameter) only of some parts. I have seen that I can solve with:

&model_name:x or &code:x

but I can't identify which x value corresponds to the part that interests me and the co-assistance with its sub-assistance counts more than 300 parts....

What banality can I not see?

wf

 

[riccardot5765]

Can't you do a bom? so you have to create only a table of a staff and then automatically update, obviously with the parameters you want to put on

 

[wired]

...but if I do it in a set, I get the name of the axieme. .
I explain, in a table I should indicate with a note the name or code (by parameter) only of some parts. I have seen that I can solve with:

&model_name:x or &code:x

but I can't identify which x value corresponds to the part that interests me and the co-assistance with its sub-assistance counts more than 300 parts....

What banality can I not see?

wf

Hi.
You miss the component.
id serves to declare that a note, report, etc. belongs to a certain component.
I don't appeal well, there should be a command to identify the id.
I usually do this:
- assembly
- I see a share of the component I'm interested in
- info/switch size
proe shows me something like d12:25
25 is id of the component.
go into drawing and create the note like this:
&model_name:25