creation insole sidewalk - problem

[duken]

I have to create a pavement in my building ( Square Plant).
1 - I create the level "sole pavement".

2 - they place me in the plant "seat sidewalk" and design a "reference floor" in the end of the north wall.

3 - renounce the reference plan "sole pavement".

4 - now, always in plant,create a local square mass covering the entire surface of the plant.

5 - without confirming ends mass, they place me in the north front.

6 - always with the active local mass select line and a "worktop" window appears, I go on "select plan" and I see the list of levels, but not the reference plan first created.


My goal is to create the profile of the sidewalk in front and then create a solid through "create form" that rotates around the whole building.

any advice on the problem listed?

 

[emi_973]

hi, sorry but why don't you use the floor command (opportunely layered) to create the sidewalk? offset works to place it less than 2 from the internal p.p.f., you could also insert the bottom screed with variable thickness for a possible slope... unless you have special needs, it seems to me that in doing you complicate a little life.