creation of a gallery in civil 3d

[zhodiac8418]

Good morning to all,
I have the design of a track, to be realized with civilization 3d, which develops with a gallery, but I don't even know where to go. precise that I am new to the use of civilizations. I tried adding to the type section created (c2) the tunnel element from the tool palette it subassembly of the country kit italia, and eliminating the shoe at the edges of the section, but I do not know if it is the right way. In addition I would like to know how to add the realization of the filling portal.
thanks in advance for help and response

 

[Tristan]

I have the design of a track, to be realized with civilization 3d, which develops with a gallery, but I don't even know where to go.

since you are "new to the use of civilization" you may start from a training course. . .

 

[zhodiac8418]

since you are "new to the use of civilization" you may start from a training course. . .

Good morning, actually I have already taken 2 courses of nke on civil 3d, none of which however had the subject of the treatment of tunnels.

 

[Tristan]

then the thing is different. You're not so "new." . .
the workflow to create a runner is always that: studies the planoaltimetric axis and to this associ the section/s type.

I tried adding to the type section created (c2) the tunnel element from the tool palette it subassembly of the country kit italia, and eliminating the shoe at the edges of the section, but I do not know if it is the right way.

the road you have undertaken is correct.
for the filling, depends on how it should be realized; could be necessary to model it as solid autocad if the shape is particular

 

[zhodiac8418]

then the thing is different. You're not so "new." . .
the workflow to create a runner is always that: studies the planoaltimetric axis and to this associ the section/s type.

the road you have undertaken is correct.
for the filling, depends on how it should be realized; could be necessary to model it as solid autocad if the shape is particular

the problem is that, following this road, when I go ahead (and I had the retry importing everything in infraworks) something is not going, because the runner automatically creates me the debankment of all the interested side, instead of creating and accounting the only “scavo” of the gallery.

 

[Tristan]

then you must have wronged something in creating the type section. If, as you say, you wiped out your shoes, this should not happen

 

[Tristan]

for the filling. example (it is not a gallery, it is an underground rio, but the concept is the same):
those walls and combs are not feasible through a civil 3d runner; were then modeled with autocad and all was exported to ifc

 

[zhodiac8418]

Thank you very much for the answers and suggestions