creation sections with parallel floors

[bagarospo81]

Hello everyone,
It's just that I use creo (version 2.0) I don't find myself much compared to the cads I learned a bit to use (solidworks and inventor)..in partcular on the table I'm struggling very hard.
I would like to create a section view with parallax planes (not the classic straight track but with broken track) but I don't understand how to do it.
Can you give me some tips?

 

[bagarospo81]

Sorry I found the answer always on the forum...and so the discussion could close.
I would, however, need to help on the table, which I open a new discussion or support myself on this?