andreamignitico
Guest
Hello, everyone.
I make an example so I can explain.
I have a 5mm deep quarry. has 3 closed sides and one open.I impose the crude of 5mm wider.on milling open a new milling window.
I wanted to figure out how to get the ultensile out of the milling window.even setting up tool stroke outside the window limit always stays inside me.
in practice I don't want the tool to leave me the fried ray when it goes to do the open side
Thank you.
I make an example so I can explain.
I have a 5mm deep quarry. has 3 closed sides and one open.I impose the crude of 5mm wider.on milling open a new milling window.
I wanted to figure out how to get the ultensile out of the milling window.even setting up tool stroke outside the window limit always stays inside me.
in practice I don't want the tool to leave me the fried ray when it goes to do the open side
Thank you.