crushed fold

[marcomx]

Good morning to all,
I would like to ask you a question about the crushed fold.
I press that this operation I do without any problem with solidedge from version 19 (so for about 10 years - 14 versions ago!).
I have to make a panel with a crushed edge.
I have a stretch of straight sheet, a radiated stretch say r=100mm with angle 45° and another straight stretch.
on these traits I have to make a crush as from image. problem on the curved section where I can't do it.
graphically I ovviato doing 3 parts and joining them together but clearly no longer develops as sheet metal.
for the workshop I think to correct by hand the dxf going to add the crushed on the curved part (I do it on the sheet side without the crushed on the curve).
I tried with 2019, I don't know if 2020 can.
I don't know if there's a more agile way to do that.
how would you solve?
Good day

 

[MassiVonWeizen]

on a curve it is not possible to make any bend
here a discussion with a similar problem

 

[marcomx]

I figured. I also tried the flex function but with little results.
also with solidedge clearly you can not add folds on a curved part but the crushed cutting si.

thanks anyway massive for the answer celery.
Good day

 

[scalva]

If you care for representative purposes you can do it with sweep extrusion but it is not a sheet.... .
Also you have to leave a few cents of air when drawing the sketch of the folded profile.

 

[marcomx]

hi at first I had done as you say but then I preferred to do as said in the first post because playing with configurations I can extract the development of the part without crushing on the curved tract.

 

[MassiVonWeizen]

bhé, but if you don't tell me I'm rh@@♦ito and I forget to put the links...

Disegnare lamiera particolare

Buongiorno, ho provato in tutti i modi, ma non sono riuscito ad ottenere niente... Devo modellare una lamiera come quella in foto e sono riuscito a fare tutto tranne il bordino che ho evidenziato E' un brodo largo 20 mm che segue il profilo tondo ed inclinato della lamiera ed è anche piegato...

www.cad3d.it

Problema sviluppo lamiera SW2017

Buongiorno a tutti ho un problemino con una lamiera piegata in cui vi sono due pieghe in contrasto una con l'altra e non riesco a disegnarlo come lamiera e quindi non mi crea lo sviluppo (file in allegato) Riesco a fare, o la piega longitudinale a 30°, oppure la piega a raggio 900mm...

www.cad3d.it

 

[marcomx]

I had seen those discussions before.
by curiosity I tried with solidworks 2020 with the same results.
Even inventor 2020 fails