boxer87
Guest
hi I would like to know how to import and use a custom profile (extruded in aluminum that is usually used in automation) in the chassis generator.
Thank you very much
Thank you very much
Tarkus
Guest
depends on what release you have:
since 2009 there is the special command "creation structural form" in part environment.:smile:
So you're clearing your extruded profile and you're fine.
in 2008 you can do it, but it's more Moroccan, with the r11, i.e. the release with which the fg came out, i don't remember if you could do it.
cmq, tell us what version you have.....:smile:
since 2009 there is the special command "creation structural form" in part environment.:smile:
So you're clearing your extruded profile and you're fine.
in 2008 you can do it, but it's more Moroccan, with the r11, i.e. the release with which the fg came out, i don't remember if you could do it.
cmq, tell us what version you have.....:smile:
boxer87
Guest
at work we just installed 2010
would you be so kind to turn me off the procedure? tnx
would you be so kind to turn me off the procedure? tnx
Tarkus
Guest
I haven't installed 2010 yet. I think it's like 2009, cmq is better if you have information from who has 2010.
pagnotz
Guest
in 2010 open the part with the profile to be published, then go into management -> creates -> structural form