strafede86
Guest
hello, does anyone know if the sw2010 can detect interference between feature on the same body (for example between two holes)?
Thank you.
Thank you.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Mike1967
Guest
in the "assieme" environment you can check it, even on bodies the same part.hello, does anyone know if the sw2010 can detect interference between feature on the same body (for example between two holes)?
Thank you.
for holes I find useless control, just use concentric relationships
in the sketch, in fact I think it is for this reason that there is no control
of this kind. .
strafede86
Guest
perhaps I did not explain myself well: it happens that one hole intersects another without the designer to notice; for example a threaded hole inside another hole (image image image)
I want to be able to intercept interference like this...
I want to be able to intercept interference like this...
Oldwarper
Guest
I'm hard. . .perhaps I did not explain myself well: it happens that one hole intersects another without the designer to notice; for example a threaded hole inside another hole (image image image)
I want to be able to intercept interference like this...
The first idea that I think is to make a "negative" copro so that only the holes can be seen as "full" and check that there are no contacts.
make a body equal to the previous, but without holes (make a copy of the file and suspend/tole all the features of cutting and drilling), then it amounts into the perforated body and with get the body difference between the two, which will be the "full-made holes". or do a joint with both bodies and with "cavity" you will remove the perforated body from the full body. already from the command you can have an idea of the bodies that you will get and maybe you will see the two intersecting holes that are one body.