diagrams electrorosion hitachi sp600

[rinato]

Hello, I hope I'm not too out of place.
I am looking for the electrical schematics of a wired electrorosion hitachi sp600 (fanuc control 6m ). It's a mid-1980s machine, but maybe some molders still use it.
ours is freaking out (you only want to work dry... ) but we are without electrical schematics because probably, at the time, never provided.
also accept suggestions or proposals. even in mp.
Thanks for any help, reborn.

 

[rinato]

Hello again, the car in question raised white flag.
who uses them/knows, what would you recommend between makino, mitsubishi, age-charmilles? ~600x400 racing.

 

[Lucky66]

Hello again, the car in question raised white flag.
who uses them/knows, what would you recommend between makino, mitsubishi, age-charmilles? ~600x400 racing.

Hi.
I had agie despite working a lot are still very precise,charmilles/agie oramai are part of the same group, even makino is a great car, mitsubischi I have seen very few at workshops.
Hi.

 

[rinato]

Hello, for information to whom we were interested, we oriented on the fanuc. is the most compact one, and between her and the makino danced at least 20k €, not justifiable for 50mm extra race on the axes (which beyond all made it too wide).
the other: charmilles looks like an organ of the 700>> > very much layout, and an operator met during the exploration has not recommended it. badly integrated pc.
ona was bellina, but the tower of the highest wire for the operator, and of the cables, inside the chin, which went from the generator to the working area were warm, with pieces from 40-50mm...pc with os +/- owner.
mitsubishi, after the childhood interest in linear engines, had some matte point, like "is Chinese" "no is jap" "no is Chinese" ... non ergonomic pc
accutex, Taiwanese with a few arrows to its arc on the filter side, for the rest it is of a previous generation, without avancing on the cost.
Sodick didn't even look.

of the fanuc, after a few months of use, only positive notes. a little bit of secondary is always known, to have preferred better, but so much.

Reborn.

*backup of the configuration on pcmcia card (+o-), which is now struggling to find, usb1.1 mouse port, that also those are in the way of extinction, support plans pieces a little 'soft' compared to the abandoned fanuc-hitachi, some wiring on the back little "zen", insufficient tub lights (but already provided, to the emo2015...).