ulio82
Guest
Good evening to all,
I kindly ask any more expert than me in the kinematics environment, how to do to simulate the movement of the pneumatic cylinder (race 100mm).
the cylinder, as observed in the attached file, is connected via flange to a plate that must flow on two guides. the position of the cylinder in the axieme is completely extended. I would like to simulate a translation of the latter in backwards until the point of race 0.
Thank you in advance for your advice.
I kindly ask any more expert than me in the kinematics environment, how to do to simulate the movement of the pneumatic cylinder (race 100mm).
the cylinder, as observed in the attached file, is connected via flange to a plate that must flow on two guides. the position of the cylinder in the axieme is completely extended. I would like to simulate a translation of the latter in backwards until the point of race 0.
Thank you in advance for your advice.