drive threaded hole and n° series instances by parameter

[Tonolli]

Hello everyone, I am new to the forum, and of course I need help! !
in pro/e wf 4 I need to drive from parameters the execution of features.
in the specific case I would like to have in a parameter the thread to do (m3, m4, m20...) and make a threaded hole guided by the parameter.
I would also like to check (always with a parameter) the number of feature repeats in a series but I can't put the parameter in the box.

thanks in advance to all

 

[AMinati]

if you use threaded holes I think you should insert all possible threaded holes and with pro/program suppress/retake the desired feature.

for the other problem in reports write p### = number_repetitions
where p### is the variable of the number of instances of the series under review and number_repections is your parameter (full)

aminati