electrode

[MATTE78]

Hello, everyone. I have to build an electrode giving a gap of 3 tenths. I don't have the electrode module. I thought of using the scale function, but you can't put the gap value but only the scale factor. Do you have any advice?
Thank you.

 

[iuri]

I usually use the surface offset... .

 

[cimaguy]

Hello, everyone. I have to build an electrode giving a gap of 3 tenths. I don't have the electrode module. I thought of using the scale function, but you can't put the gap value but only the scale factor. Do you have any advice?
Thank you.

hi, if you have to draw an electrode and then you have to do the cam, draw it to zero with the super factories and when you do the processing,imposti a negative value of offset surfaces equal to the gap

topguy

 

[MATTE78]

thanks to all of the answers! Hi.

 

[SHIREN]

can vary in the cam the value of the milling diameter
example
fried by dia.20 imposed on the value of 19.70
if you need change the value of z -0.3
Thank you very much

 

[iuri]

you can also activate the electrode milling function, which also works without electrode module. I never used it, but I think it's good for her job.

 

[cimaguy]

you can also activate the electrode milling function, which also works without electrode module. I never used it, but I think it's good for her job.

... does the same work as the negative offset on surfaces